01About

• Four pairs: gingerbread man, candy cane, snowflake, tree
• Layered colors you can see and feel
• Every charm 2.4 mm thick, with a 2 mm hole for a jump ring
• Prints flat with no supports
• All four pairs on one plate, or one pair at a time
• Sell the earrings you make

• Christmas
• Earrings
• Prints flat
• No supports

02How to print

1. 1

   Open the 3MF in Bambu Studio

   Open it as a project (File, then Open Project). The printer, plate and settings are already saved, so there's nothing to set up. Printing on another brand? Use the STL files with the settings below.

2. 2

   Load your filament

   You need 5 colors:

   • Gingerbread, tree trunkCaramel
   • Buttons, stripes, disc, ornamentsRed
   • Icing, cane, snowflakeWhite
   • Bow, treeDark Green
   • StarYellow
3. 3

   Print

   Print everything on the list below, then put it together.

The gingerbread man, candy cane and snowflake change color only between layers: print them with pauses and filament swaps (the guide lists the layers). The full-color tree has several colors in the same layers, so it needs an AMS; without one, print its STL in one color. All four pairs on one plate needs a four-color AMS and uses yellow in place of caramel. Keep the scale at 100% so the 2 mm holes fit the hardware.

03What to print

8 charms in 4 pairs. The whole collection:

Each file prints a pair, or all four pairs at once. Use its 3MF or its STL, not both.

04Putting it together

1. 1

   Pick a file per pair

   Open a pair's 3MF as a project, set up for a Bambu Lab P2S, or use its STL in any slicer, not both. Or print all four pairs on one plate.

2. 2

   Print them flat

   Decorative face up, no supports, no brim. For the gingerbread man, candy cane and snowflake, pause between the color layers and swap filament. The full-color tree needs an AMS; without one, print its STL in one color.

3. 3

   Clean the loops

   Let the charms cool before lifting them by the broad body, then remove any strings and check each 2 mm hole.

4. 4

   Add the hardware

   Pass a jump ring through the charm and the ear wire's loop and close it. Hinged click jump rings about 6 mm across, with wire up to 0.8 mm, need no tools. Ear wires and jump rings aren't included.

5. 5

   Wear them

   Each charm hangs face forward from its loop. No glue anywhere.

Keep finished earrings away from heat that could soften the plastic, keep small parts away from young children, and check each pair before wearing or selling it.

05Selling your prints

Every download comes with a license that lets you sell the physical prints you make. The full terms are in LICENSE.txt inside the ZIP.

Want a friend to have the files? Send them this page. Read the full license